EMAK OM124J User Manual download pdf (Page 28)

 Into the upper holes in the brace that fastens the front tube above, insert M5x16 bolts,

secure them with washers and nuts, and lightly tighten them. Also tighten the lower,

pre-inserted bolts.

3.3.2h

For the catcher on the 360-litre model, a spring (brace) must be bolted into the lower hole

on the right-hand side of the front tube, for hitching up the basket.

 Unscrew the two nuts on the opposite corners of the frame, slip the corner braces on and

screw the nuts back on. Make sure not to get the left brace and right brace switched. The

left brace is clearly marked “L”.

3.3.2i

 Bolt the catcher’s side braces on. The braces are fastened from the inside of the catcher

using a bolt, washer and nut.

3.3.2j

For the catcher on the 360-litre model, ignore this point — the side braces are premounted.

 Bolt the lower tube to the frame. For easier assembly, we recommend turning the catcher

upside down. Fasten the lower tube from the lower side to the corner braces and to the

front frame. After assembly, turn the catcher right side up.

3.3.2k

 Slide the catcher bag back on. Pull the rubber edge of the bag over the tube.

3.3.2l

 Bolt the two lower braces to the underside of the lower tube.

3.3.2m

On the 360-litre model, only one lower brace is fastened. It is bolted to the side brace.

 Insert the handle into the holes in the lid and slide the black washers onto the bolts. Then

slide the plate onto the bolts and another set of washers.

 Take this whole assembly and push it into the holes in the upper bracket of the frame, slide

another set of washers onto the bolts and secure them all with nuts. Do not tighten them

yet!

3.3.2n

For the catcher on the 360-litre model, first put on the washers (black) and after that insert

the handle into the lid. Between the lid and the the basket structure there are washers but

no plate.

 Bolt the lid to the frame and tighten the bolts.

3.3.2o

 Insert the emptying lever into the holes in the brace inside the catcher.

 Into the lower end of the lever inside, insert a bolt and push its threaded portion through

the hole. Secure it from above with a nut and tighten it.

3.3.2p

 Tighten the nut securing the handle. This completes installation of the grass catcher.

3.3.2q

BALANCING AFTER INSTALLATION

 Take hold of the grass catcher and hang it on the hangers on the rear plate of the machine.

 Check its fit to the fenders. Correct any imbalance by loosening the bolts in the front tube and/or the

bolts in the side braces, evening it up and retightening the bolts.

 If the catcher cannot be fit in the manner explained above, balance it by shifting its hangers on the

rear plate.

 After balancing the catcher, adhere the triangular sticker (included) on its lid. Place it across from the

sticker that is already adhered to the machine’s cover. The tips of the triangles must be in opposing

positions.



1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 53 54

Comments to this Manuals

No comments

EMAK OM124J User Manual Page 28

Comments to this Manuals

Related products and manuals for Lawnmowers EMAK OM124J